G.
After the system connected with power first time, the telephone number
of the first phone call to the main unit is the master telephone no, just dir-
ectly input the 2 command code to operate the system, other telephone
no must input the operation code +2 command code(the operate code is
123456 for factory setting, it must be changed, "+" no need to input, bef-
ore operate please read the command code table)
H.
Clear the master telephone no: open the door after disarmed, foot on
bark, turn the key from OFF to ON 3 times, and put the Key at ON position
at the third time, the siren will sound 1 time, then turn off ACC, release the
foot bark and close the door. The system will clear the command telepho-
ne no. If you want set it again, please dial the SIM card no in the main unit,
after connected the new no will be the command telephone no.
3. Installation
：
A.
Before installation you must prepare one SIM card works GSM network,
Through this no you can contrl this system, and please make sure it have
enough balance to make phone call and with GPRS function active, all
the remote controls and the alarm reports will be fulfilled through this SIM
card. So please protect it and keep it secretly.
B.
Please install the GPS alarm system by the installation diagram and the
wire diagram, please install the main unit and the GPS antenna and the
GSM antenna at a secret place.
C.
After wires connected, please disconnect the power and the backup
battery, plug in the SIM card, and connect the power first and then plug in
the backup battery, under any status if the power wire was cut off, the sy-
stem will sending message and make phone call to the owner with alarm
report
“
Attention, system power was cut off
”
when the system re-conn-
ected with power, the backup battery will be charged and the system will
reply with message
“
the external power re-connected
”
.
D.
After 1 minutes when connected with power, please dial the no of the
SIM card inside of the main unit, when hearing
“
system connected plea-
se operate
”
it means the system was connected successfully and setting
the mobile no as the main command no(After first time power connected,
the first no dialed the main unit is the command no), if hearing
“
the no
can not be reached
”
, or
“
the no you dial is powered off
”
it means the
system not connected successfully, and command no setting failed, ple-
ase disarm the system and disconnect with external power and backup
battery, then check the GSM antenna connection and make it connect well,
and check the SIM card be place well, and after checking please re-conn-
ect the po-wer and the battery, and then dial the main unit no again.
Attention: if hearing
“
the system is calling
”
, please disarm the system
and disconnected the power and the back up battery for 1 minute, and re-
connect them, after 1 minute disarm the system and open the door, foot
on bark, and turn the key from ACC off to ON 3 times, and stay at ON pos-
ition at the third time, and after siren sound 1 time, turn off ACC, release
the foot bark, and close the door, the system will clear the command no,
and then dial the main unit no with your own mobile to setting the comm-
and No.
E.
The system and the mobile connected successfully and setting the m-
obile no as command no it means installation successfully, user can set-
ting other function and operate the system by their own needs.
(3)
(4)
R
ON
+12V
ACC
ON
Start
ON
Start
+12V
ON
ACC
Engine Start Moudule Installation Circuit
Brown
Yellow
Red
Black
Brown
Blue
Bypass moudule
Engine
start
connection
GND wire
GND wire
