10.
Setting up and adjustment:
-
With the unit in momentary operation (See
Modes of Operation: Dual stage linear sensitivity
above),
use a terminal screwdriver to turn the sensitivity control fully clockwise to maximum (Position 6).
-
Using a suitable implement, bang or tap the protected area, observing the LED response.
-
Reduce the sensitivity by a small amount (turn sensitivity control anti-clockwise) and bang or tap the
protected area.
-
Repeat this process until the unit only just responds to the desired impact.
11.
Replace the sensor cover, tighten the fixing screw and check its response to the desired impact.
PRT-PSU-DIN-4A | Protege DIN Rail 4A Intelligent Power Supply | Installation Manual
12