ICS SB686P Series, Руководство по эксплуатации продукта

Страница: 117 / 126

Manual Number: 40110-005-2 Page 107
Screen Saver Mode
The Screen Saver Mode section has four check boxes in it. They are Reduced On, StandBy,
Suspend and Off. The screen saver detects the type of graphics controller being used and the
power saving capabilities it has.
If the text immediately to the right of any of the check boxes is unavailable, that option may not be
selected. If a power saving mode is available, the text immediately to the right of the check box is
black. If the box is selected with the mouse or the keyboard, the rest of the fields on the line also
turn black. If the check box is deselected, the other fields turn gray.
Minutes Field
The minutes field for each line can be changed only if the check box for that line is selected. The
amount of time can be set for any number between 1 and 60. The number be entered by manually
typing or by clicking on the up or down arrow next to the number. Holding the mouse button down
on the arrow quickly increases or decreases the minutes field.
The number of minutes specified for each level is the number of minutes after the previous mode
has been enabled. It is not the total time before entering that mode.
Screen Saver Animation Speed
The scroll bar controls how fast the animation moves. The check box controls whether or not a
bouncing sound is played whenever the logo hits an edge of the screen.
Password Options
If the password check box is enabled, the screen saver prompts the user for a password before it
quits. The password is the same one used for other Windows 3.X screen savers.
Windows 95
This section describes the installation and setup instructions for Windows 95.
1. Click on the Start box and proceed to Settings, Control Panel. Open the Control Panel and select
the Display icon or right click on your Windows 95 desktop to show the Display Properties
dialog box.
2. From the Display Properties dialog box, select the Settings tab and then select the Change
Display Type button.
3. From the Change Display Type dialog box under the Adapter Type section, select the Change
button.
4. From the Select Device dialog box select Have Disk.
5. Insert the CIRRUS LOGIC Windows 95 Drivers & Utilities disk into floppy drive A: or B: and
select the OK button.
6. From the Select Device dialog box select either the CIRRUS LOGIC 5446 PCI with VPM
DirectDraw V1.00 or 5446 VLB Display Drivers. Select OK and then Close to exit the
Change Display Type menu. Select Close again to exit the Display Properties folder. Select
Yes to restart the computer before the new driver takes effect.