Power Switch Setup 3-11
Sy
st
em Inst
alla
tio
n
Power Switch Setup
Momentary Power Switch Setup (ATX Power Supplies Only)
*
To configure the single board computer to accommodate Omnix chassis with a
momentary power switch, follow these steps:
1)
Select jumper pins 1-2 on JP3, AT/ATX Power Select (Figure 3-1).
2)
Connect J12, ATX Power Button Interface, to the momentary power switch
on the chassis.
3)
Route ATX signals from the power supply to J10, ATX Power Control
Connector.
Figure 3-1. JP3, AT/ATX Power Select, Jumper Pins
* See “Wiring Diagrams” in your chassis user’s guide.
JP3
1
2
3
Select Jumper Pins 1-2
