![background image](http://html1.mh-extra.com/html/ics/890f4/890f4_operators-manual_3559215029.webp)
© 2017 ICS®, Blount International Inc. REV072517 P/N 566594
890F4 OPERATOR MANUAL
29
MAINTENANCE
IMPORTANT
Maintenance
SYSTEM CLEAN-UP
•
After cutting, run the power cutter for at least 15 seconds with the water on
to flush slurry and debris from diamond chain, guidebar and drive sprocket.
•
Wash concrete slurry and debris from power cutter assembly.
•
Remove guidebar and chain. Flush out the chain tensioner and side cover
with water. Lubricate tensioner with waterproof grease.
•
After cleaning the power cutter, spray the entire power cutter body, chain,
guidebar, and drive sprocket with lightweight oil. Using lightweight oil on
the power cutter will minimize rust and help reduce slurry build up.
AFTER EACH USE
•
Inspect drive sprocket for wear
•
Inspect and tighten all fasteners as necessary.
•
Flush and rinse the power cutter, guidebar and chain with water
•
Check trigger function assembly
•
Check mud flap for tears or damage
•
Check guidebar and chain for damage or missing segments
•
Check trigger cover bubble levels
•
With power cutter disconnected from power source, check hose whips
for leaks or damage.
•
Inspect drive sprocket for wear.
• Replace when the drive teeth are worn more than half way through.