ICS 680GC, Руководство оператора

Страница: 18 / 28

© 2009 ICS, Blount Inc. F/N 525746 Jan 09
TITLE 680GC OPERATOR’S MANUAL
18
MAINTENANCE
AIR FILTER
IMPORTANT
STARTER HOUSING ASSEMBLY
It is common for concrete slurry to get inside the starter housing
assembly during cutting. This can cause the starter pawls to stick
and not engage when the rope is pulled.
IMPORTANT
• After each usage, thoroughly flush the starter housing
assembly with water. (Figure 3)
• Lubricate the starter pawls by spraying light weight oil into the
starter housing through the vents. (Figure 3)
• Check the starter cord for fraying, replace if necessary.
Figure 3
The air filter is made from a nylon micro mesh air filter and an
internal spit-back screen. Both must be kept clean for the engine
to operate properly. If the saw is not reaching full RPM, most
likely one or both of the air filters are dirty.
• The air filter (Figure 1) should be free of holes and white
in color.
• Replace air filter when dirty.
• The spit-back screen (Figure 2) should be free of holes
and be white in color. Clean with mild solvent or gasoline
and dry with high pressure air. If spit-back screen is dirty
the saw will not reach full RPM.
• During re-assembly, tighten air filter wing-nut "finger tight"
plus an 1/8" of a turn with wrench.
Figure 1
Figure 2