Connecting the LEX to the REX
With Surface Cabling
1.
Plug one end of the Cat 5e cabling (not included) into the Link port (RJ45) on the LEX.
2.
Plug the other end of the Cat 5e cabling into the Link port (RJ45) on the REX.
With Premise Cabling
1.
Plug one end of a Cat 5e patch cord (not included) into the Link port (RJ45) on the LEX.
2.
Plug the other end of the patch cord into the Cat 5e information outlet near the host computer.
3.
Plug one end of the second Cat 5e patch cord (not included) into the Link port (RJ45) on the REX.
4.
Plug the other end of the second patch cord into the Cat 5e information outlet near the USB device(s).
Connecting Power to the LEX and REX
1.
Plug the supplied 5V, 3A power adapter into a suitable AC outlet near the LEX.
2.
Connect the power adapter to the LEX.
3.
Plug the supplied 5V, 3A power adapter into a suitable AC outlet near the REX.
4.
Connect the power adapter to the REX.
Use only the power adapters supplied with the product. Use of substitute adapters may cause permanent
damage to the system and will void the warranty.
Checking the Installation
1.
On the LEX and REX units, check that the Power, Link, USB, and Video LEDs are on. If the Link LED is off,
then the cabling between the LEX and REX unit is not installed properly or is defective.
2.
Check to see if the USB LED is on and the Video LED is blinking or on, if they are not, this indicates
there is no USB data or video data. Check the HDMI and USB connections to the host computer, and
the HDMI connection to the monitor. Check to see if any USB devices are connected to the REX.
3.
If the product is not displaying video or your USB device fails to be detected by your operating system,
consult the Troubleshooting Guide.
Connecting a USB Device
1.
Install any software required to operate the USB device(s). Refer to the documentation provided for
your USB device(s), as required.
2.
Connect the USB device to the device port on the REX.
3.
Check that the USB device is detected and installed properly in the operating system.
9
