65
Appendix D. How to use Wake-Up
Function
The ROCKY-3782EVS provides two kind of Wake Up Function.
This page describes how to use Modem Wake-Up and LAN Wake-Up
function.
Wake-Up function is working while you use ATX power supply,
Wake-Up By Modem Ring On
:
You must set the option
Power On By Ring
of CMOS SETUP to be
enabled. The ATX power supply will be switched on when there is a ring
signal detected on pin “RI” of serial port.
Wake-Up On LAN
:
When your computer is in power-down status, you can see LAN
Link/Active LED is flashing. This status indicates that the LAN chip has
entered standby mode and waits for Wake-Up signal. You can use other
computers to wake up your computer by sending ID to it.
ID: ID is the address of your system LAN. Every LAN chip has a factory-
set ID which you can find it from network information in WINDOWS.
ID’s format is xx-xx-xx-xx-xx-xx
Example ID
: 00905C21D4
