ROCKY-3702EV Socket 370 Celeron
TM
& Pentium III
with AGP VGA & 10/100Mbps Ethernet SBC
28
Offboard PCI IDE Primary (/Secondary) IRQ >
to specify the
PCI interrupt that is assigned to the Primary (/Secondary) IDE
channel on the offboard PCI IDE controller.
PCI Slot (1,2,3,4) IRQ Priority >
to specify the IRQ priority to
be used by the PCI devices on slot 1 to 4.
DMA Channel (0,1,3,5,6,7) >
to indicate whether or not the
DMA channel is assigned for a PnP or ISA card.
IRQ (3,4,5,7,9,10,11,14,15) >
to assign the displayed IRQ to be
used by a legacy ISA adapter card. The settings are ISA/EISA or
PCI/PnP.
4.7 Peripheral Setup
This setup is working mostly on Multi-I/O Chip (W83977F). The
options are used to change the Chipset‘s registers. Please
carefully change any default setting to meet your application
need perfectly. The only special concern is Onboard Serial Port
2. If you want to use the IrDA port, you have to configure the
SIR or ASKIR model in the BIOS’s Peripheral Setup’s COM2;
the RS-232 COM2 will be disabled.
Onboard FDC >
to enable the FDC on your board. If you set it
Auto, the BIOS will decide if the FDC should be enabled,
automatically).
