C-4
ICP Flash Utility (IFU)
Running the IFU from the GUI
The easy way to run the IFU is to use its GUI. If you prefer to run
the IFU from the command line, see
To access the IFU:
1
Create the firmware floppy disks, as described in
.
2
Shut down your operating system and reboot to DOS from a
bootable MS-DOS floppy disk or from a DOS partition on a
bootable drive. You can use the drive connected to the controller
you are updating.
Note:
When updating the controller flash, I/O is not
possible. Before you can use the controller again, complete
the flash operation and restart the computer.
3
At the DOS command prompt (typically
A:\>
), type
IFU
with no
arguments.
The IFU’s main menu is displayed.
4
Select
Select Controllers
and select the controllers to be flashed.
5
Select
Select an Operation
.
6
Select any available IFU function and follow the on-screen
instructions.
