C-5
ICP Flash Utility (IFU)
Running the IFU from the Command Line
At the DOS command prompt (typically
A:\>
), type
IFU
followed
by a command and any switches. The IFU processes the command,
prompts you to insert additional floppy disks as needed, exits, and
reports success or an error message code.
Command Summary
This section describes each IFU command (in alphabetical order).
HELP
The
HELP
command displays a summary of IFU functions and
command switches.
Examples
The following are examples of commands you can use to display
help information:
A:\> IFU HELP
A:\> IFU /?
LIST
The
LIST
command displays the IFU-supported controllers
installed on your computer. Use this command to see which
controllers are installed, or to identify the ID numbers assigned to
each physical controller.
You do not have to restart the computer after completing this
command.
Example
The following example shows a typical response to a
LIST
command.
A:\> IFU LIST
ICP Flash Utility V4.0-0 B5749
(c)ICP Inc. 1999–2002. All Rights Reserved.
Controllers Detected and Recognized:
Controller #0 (03:05:00) ICP 2410
