ICP ICP9014RO, Инструкция по установке и эксплуатации

Страница: 39 / 142

3-8
Installing the Driver
UnixWare and OpenUNIX
This section contains the following procedures:
■
Installing the Driver When You Install UnixWare or OpenUNIX
■
Installing the Driver in an Existing UnixWare or OpenUNIX System
Note: Although the driver disk you create for UnixWare and
OpenUNIX differ, the installation procedures for these
operating systems are the same.
Installing the Driver When You Install UnixWare or OpenUNIX
To install the driver when installing UnixWare or OpenUNIX:
1 Install and configure the controller and hard disk drives, as
described on
page 2-2 .
2 Create the bootable array, as described on page 2-4 .
3 Create the driver disk, as described on page 3-2 . When finished,
remove the driver disk.
4 Insert the Unix installation CD and start the operating system
installation.
5 When you see the prompt, insert the driver disk, select Install
HBA diskette , and then press F10 .
The computer loads the driver from the driver disk and
displays the HBA screen.
6
Select Proceed with Installation , then press F10 .
7
Complete the installation as appropriate.
8 When the installation is finished, remove the driver disk and
restart the computer.
Installing the Driver in an Existing UnixWare or OpenUNIX System
To install the driver in an existing UnixWare or OpenUNIX system:
1
Shut down the computer. Install and configure the controller
and hard disk drives, as described in
Chapter 2 .
2
Create the driver disk, as described on page 3-2 . When finished,
remove the driver disk.
3 Turn on the computer, then insert the driver disk.