3-5
Installing the Driver
Installing the Linux Module
This section contains the following procedures:
■
Installing the Module When You Install Red Hat or SuSE
■
Installing the Module in an Existing Linux System
Note:
For the most up-to-date information on ICP’s support of
Linux, visit
www.icp-vortex.com
.
Installing the Module When You Install Red Hat or SuSE
To install the module during a fresh install of Red Hat or SuSE:
1
Install and configure the controller and hard disk drives, as
described on
.
2
Create the bootable array, as described on
3
Create the driver disk, as described on
remove the driver disk.
4
Insert the first Red Hat or SuSE installation CD.
5
Restart the computer.
6
When the Red Hat Welcome screen appears, type
expert
at the
Boot:
prompt.
7
When prompted, insert the driver disk, then select
OK
.
8
Follow the prompts to set up your preferred environment.
9
If you are installing other third-party devices, proceed with the
installation of those devices. Otherwise, select
Done
.
10
Proceed with the Linux installation according to the Red Hat or
SuSE instructions.
