Hardware Installation and User’s Guide
13
Hardware Installation
Warning:
Attention the controller CPU can get HOT!Controller requires constant airflow for
cooling (min 1m/sec).
Figure 2-2. Installing the ICP RAID Controller into a Computer System
2.1.3
Changing Jumper Settings
The ICP RAID controller normally comes ready to be installed into the computer
motherboard immediately. However, jumper settings are available to:
•
Reprogram the RAID firmware that is located in the flash memory of the ICP RAID
controller.
•
Change the configuration for SCSI power and/or termination.
The board contains 3 jumper blocks to control the functions described in
Table 2-1
. See
Figure 2-3
for jumper locations and pin numbers, and see
Appendix A
for a detailed
description of jumper J4.
PCI
