ICP GDT6618RD, Дополнение

Страница: 56 / 111

56
The „ERROR“ state of an Array Drive is very critical. There are several procedures in the ICP
Controller’s firmware to handle such cases an bring back the Array Drive in operation with-
out loosing data. The most suitable procedure for the specific case, should be elaborated
with your system administrator or our technical support. (Note: ICP vortex offers 2-day
RAID Workshops in our training center, which also focus on the resolution of such prob-
lems.
C.4.3 Menu Advanced Setup: Configure Controller
C.4.3.1 Menu Advanced Setup: Configure Controller, Controller Settings
Within the Controller Settings all relevant
parameters and settings concerning the
ICP Controller itself can be changed. All
information concerning Physical, Logical,
Array and Host Drives are stored twice
(
primary and secondary configuration data ) on
each hard disk. I.e., the ICP Controller
itself carries no configuration data of a
specific disk array. Out of this reason, the
migration of Host Drives between ICP
Controllers is very easy and secure, even
if the SCSI IDs and channels are changed.
Simply connect the hard disks to the new
ICP Controller, and the Host Drives will
automatically available again.
The various parameters and settings have
the following meaning:
Parameter Alternatives Description
Cache On
Off
ICP Controller cache (write and read cache) On
ICP Controller cache (write and read cache) Off
Delayed Write On
Off Write cache On
Write cache Off
BIOS Enabled
Disabled
Removed BIOS enabled
BIOS disabled, but <CTRL><G> allowed
BIOS and <CTRL><G> disabled
BIOS Warning Level All Messages
Fatal Errors
All ICP BIOS warnings and errors are displayed
Only fatal messages are displayed
SETUP from Flash-
RAM Disabled
Enabled <CTRL><G> not possible
<CTRL><G> allowed