Ethernet I/O Modules
ICP DAS CO., LTD.
PETL/tET/tPET DIO Series User Manual, Ver. 2.2, Aug. 2017, Page: 77
5.3 Several Modules Polling the Remote DI
(M-to-1) (Polling Mode)
Step 1: Connect the device to a Network, a PC and a Power supply.
Confirm that the PETL/tET/tPET series modules and remote slave device are functioning correctly.
Refer to
Chapter 3 “Getting Started”
for more details. An example configuration shown below:
Note that tPET-P2POR2, tPET-PD2POR2 and ET-2260 modules are used in this example.
Step 2: Configure the Ethernet Settings
Contact your Network Administrator to obtain the correct network configuration information for the
PETL/tET/tPET series modules and remote slave device (e.g., tPET-P2POR2 #1, tPET-PD2POR2 #2 and
ET-2260), such as the IP Address, Subnet Mask, and Gateway details. Refer to
Section 3.4 “Using the
eSearch Utility to assign a new IP”
for more details.
Figure 5-3.1
Figure 5-3.2
