STEPS
DISPLAY
OPERATION
Home Screen
r = Flow Rate | Default Setting
Factory Default: Lock = 8
Enter ANY Number from 0 - 9 to Set
Flow Coefficient = Input pulses x 1/k *
Only required if changing displays from one size to another
i.e. 1" to 2" pipe size
1. dSP-non | Press any key to turn on the LED back light | Default
is set to 6 seconds
2. dSP-Eco | Backlight LED function is not active
In dSP-non mode Backlight default is t-0006 | Set Duration Time
(sec) of Backlight to remain On.
Press any key to turn on the display to turn on LED light
(> Time = < Reduced Battery Life)
Delay Time ensures Alarm Setting only becomes active after the
flow remains constant for xx seconds
Programming the High | Low Alarm
Press + 3 Sec to Display High Alarm Setting
Press or to Enter Alarm Value.
Press to Display Low Alarm Setting.
Press or to Enter Alarm Value. The Press to Confirm
1. To Prevent Totalizer reset - Enter Password Number 0-9
(excluding # 5 ) Flow Totalizer Reset Protection Active
2. rESEt.= 5 Default = Flow Totalizer Reset Enabled
Select/Save/Continue
Move selection left
Change digit value
STR
F
F
Press and hold for 3 seconds, then press or to select
GPM
GPM
LPM
LPM
Flow Rate Units
Flow Total
|
Totalizer Units
CMH
CMH
Light On — t-5
5
▶
Flow Alarm Delay — dt-10
5
▶
Reset Totalizer — rESEt.0
5
▶
Display Mode — dSP.non
4
▶
Set Pasword — Enter #
2
▶
Changing K Factor — K= #
3
▶
Home Screen
1
▶
+
🕓
5 Sec.
Programming
In-Line Paddle Wheel Flow Meter
6
