ICON P1-NANO, Руководство пользователя

Страница: 18 / 61

18
P1-Nano V1.00
(P1-Nano V1.00)
(P1-Nano V1.00)
(P1-Nano V1.00)
(P1-Nano V1.00)
Here's an example of how it is set up in Cubase.
As you can see, when configuring the device as a Mackie controller, there is a choice of 4
possible options. Because we have set up Cubase to respond to DAW control button '2' on the
P1-Nano, we are going to select 'MIDIIN2 ( P1-Nano V1.04)'. Please note that there is only one
instance of Mackie Control, which is usually recommended for single controller devices.
Please also note, (although this is specific to Cubase), that users should use Mackie Control
in the usual way to set up their devices in Cubase 12 onwards and not Cubase's MIDI Remote
Manager. Regardless of the supported DAWs you are using, the principle will be largely the same.
Please note: For the benefit of the following examples, we are going to assume
the DAW you are connecting is DAW#1.
iCON P1-Nano V1.05
DAW #1
MIDIIN2(P1-Nano V1.05) DAW #2
MIDIIN3(P1-Nano V1.05)
MIDIIN4(P1-Nano V1.05)
DAW #3
iMAP
Now, we've covered how we allocate DAWs to the P1-Nano DAW button of your choice
(1-3) in the iMAP and, in principle, how to configure the DAW to the corresponding
MIDI port, (as depicted above), let's move on to configuring our DAW/s in the next
section.
Before we move on, let’s remember;
Step 1: Open the iMap
Step 2: Switch on the controller
Step 3: Launch the DAW/s you intend to use
Note: Please wait a few moments between each step, to ensure each is fully loaded.
The reason for the order of this process is because, as you can see from the diagram below, the iMAP
must occupy MIDI port 4 in order to communicate effectively. Unfortunately, some DAWs will automatically
try to occupy that port when launched and this will prevent the iMAP from functioning properly. The
iMAP,therefore, needs to be turned on first to make sure it occupies that MIDI port