ICON inspire 5G2, Руководство пользователя

Страница: 22 / 42

22
"Control
(CC value)"
Channel 1 to 16
Set the midi channel of
the correspondence pad
Check this box to assign
the selected channel to
all the 16-pads at the
correspondence layer
CC 1 value 0 to 127
Set the first CC value
(Pad pressed down) of the
correspondence pad
-
CC2 value 0 to 127
Set the second CC value
(Pad released) of the
correspondence pad
Check this box to assign
the selected CC value
to all the 16-pads at the
correspondence layer
Program
Channel 1 to 16
Set the midi channel of
the correspondence pad
Check this box to assign
the selected channel to
all the 16-pads at the
correspondence layer
Program 0 to 127
Set the program value of
the correspondence pad
-
Note:
Same as the key-switch, you may activate the four VirtualPort™ & the
MIDI Out port for each individual pad. So that its message will be send to the
activated port(s). To activate, “check” the correspondence check box.
3. Controller – Assign the MIDI function to your InSpire G2’s
controller
Send Data Send Data Exit Exit Send Data Send Data Exit Exit
Firmware Upgrade Firmware Upgrade
Layer1
Layer2
Layer3
Layer4
Mode
Chan
Vel
CC
Vale2
All
Device1
Device2
Device3
Device4
MIDI Out
All
Send Data Send Data Exit Exit Send Data Send Data Exit Exit Firmware Upgrade Firmware Upgrade
Layer1
Layer2
Layer3
Layer4
Mode
Chan
Vel
CC
Vale2
All
Device1
Device2
Device3
Device4
MIDI Out
All
Save File Save File Load File Load File Send Data Send Data MIDI Devices MIDI Devices
Firmware Upgrade Firmware Upgrade
Y
x
Y
x
Mode
Device1
Device2
Device3
Device4
MIDI Out
CH
Note
Down Vale
Up Vale
Led return back
select button
All
Encoder1 Encoder2 Encoder3 Encoder4 Encoder5 Encoder6 Encoder7 Encoder8
Y
x
Y
x
Y
x
Y
x
Octave
Transpose
Chan Vel Start End
Global
ZONE1
ZONE2
ZONE3
ZONE4
MIDI Out Device1 Device2 Device3 Device4
Send Data Send Data Exit Exit Send Data Send Data Exit Exit
Firmware Upgrade Firmware Upgrade
Octave
Transpose
Chan Vel Start End
Global
ZONE1
ZONE2
ZONE3
ZONE4
MIDI Out Device1 Device2 Device3 Device4
Send Data Send Data Exit Exit Send Data Send Data Exit Exit Firmware Upgrade Firmware Upgrade
Note: If you are using Mackie Control or HUI mode, you do not need to adjust
this setting. Just simply select the correct DAW mode according to your DAW
when you turn on the power. (Refer P.14 for details).
Below is described the settings for more advanced users who would like to set
up their own MIDI mapping for the InSpire G2 controller.
Diagram 12