13
15. Remove and discard the wire tie on the Main
Wire (32).
While a second person holds the Console (30)
near the Upright (2), plug the Main Wire (32) and
the Pulse Wires (31) into the matching recep-
tacles on the back of the Console.
The connectors on the Main Wire (32) and
the Pulse Wires (31) should slide easily into
the receptacles and snap into place.
If a con-
nector does not slide easily into a receptacle,
turn the connector and try again.
If you do not
connect the connectors properly, the console
may become damaged.
Insert the excess wire into the Upright (2).
Tip: Avoid pinching the wires.
Attach the
Console (30) to the Upright (2) with four
M4 x 16mm Screws (56).
See step 5.
Tighten the M10 x 53mm Screw
(73), the M10 x 20mm Screw (74), and the
M10 x 60mm Bolt (72). Then, press the
Accessory Tray (50) into place.
2
56
56
50
31
30
32
15
16.
Make sure that all parts are properly tightened before you use the elliptical.
Extra parts may be included.
Place a mat beneath the elliptical to protect the floor.
Avoid pinching
the wires