10
12
12. The Transmitter (81) requires two AAA batteries
(not included); alkaline batteries are recom-
mended.
Remove the battery cover from the front of the
Transmitter (81), and insert batteries into the
battery compartment.
Make sure that the bat-
teries are oriented as shown by the
diagrams inside the battery compartment.
Then, reattach the battery cover.
IMPORTANT: From the top of the stabilizer,
measure 11 1/2 in. (29 cm) along the Frame
(1) as shown. The Transmitter (81) must be
attached in this location.
Remove the adhesive backing from the Hook
and Loop Fasteners (79). Press a Fastener
onto the Frame (1) in the indicated location.
Orient the Transmitter (81) as shown. Press the
other Fastener (79) onto the back of the
Transmitter.
Attach the Transmitter (81) to the Frame (1)
using the Hook and Loop Fasteners (79).
81
79
1
Battery
Cover
11.5" (29 cm)
13
13. Plug the Reed Switch (80) into the Transmitter
(81).
Insert the other end of the Reed Switch (80)
into the Clamp (82).
Rotate the Flywheel (36) until the Magnet (84)
is aligned with the end of the Reed Switch (80).
Move the Reed Switch (80) so that the gap
between the Reed Switch and the Magnet (84)
is about 1/8 in. (3 mm).
36
84
82
81
14.
Make sure that all parts are properly tightened before you use the exercise bike.
Note: After assembly
is completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor.
Stabilizer
80
