ICON Health & Fitness NordicTrack VU19, Руководство пользователя

Страница: 28 / 32

28
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 20.
If the console does not display your heart rate
when you use the chest heart rate monitor, see
TROUBLESHOOTING on page 15.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFit account or iFit workouts, go to
support.iFit.com.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
TABLET HOLDER TROUBLESHOOTING
If the tablet holder does
not stay in place, rotate
the tablet holder back-
ward and tighten the
indicated screw (A) until
the tablet holder stays in
place when it is rotated
to the desired position.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. Before adjusting the
reed switch, first unplug the power adapter.
Next, remove the
Seat Post Knob
(27), remove the
Knob Shield (9),
and slide the
Shield Cover (7)
upward.
Next, remove all of the Screws (not shown) from the
Right and Left Shields (10, 11).
Then, carefully pull the tops of the Shields (10, 11)
apart and locate the Reed Switch (57). Rotate the Left
Crank Arm (20) until a Magnet (55) is aligned with the
Reed Switch. Then, slightly loosen the #8 x 18mm
Screw (34), slide the Reed Switch slightly toward
or away from the Magnet, and then retighten the
#8 x 18mm Screw.
Plug in the power adapter and rotate the Left Crank
Arm (20) for a moment. Repeat these actions until the
console displays correct feedback. When the reed
switch is correctly adjusted, reattach the parts that you
removed.
A
57
34
10, 11
55
20
MAINTENANCE AND TROUBLESHOOTING
7
9
27