ICON Health & Fitness NordicTrack Commercial 9.9, Руководство пользователя

Страница: 12 / 40

12
9
10
7
10. See step 6. Tighten the four M10 x 25mm
Screws (92).
Untie and discard the wire tie on the Upper
Wire (110).
Have a second person hold the Console (7) near
the Upright (4). Connect the Upper Wire (110)
and the Pulse Wire (63) in the Upright to the
matching wires or receptacles on the back of the
Console.
If you do not connect the Wires (63, 110)
properly, the Console (7) may become
damaged when you use the elliptical.
If a
connector on a Wire does not slide easily and
snap into place, turn the connector and try again.
Insert the excess wire into the Upright (4).
Tip: Avoid pinching the wires. Attach the
Console (7) to the Upright (4) with four
M4 x 16mm Screws (101);
start all the Screws,
and then tighten them.
101
9. Apply grease to one of the Pedal Arm Axles (64).
Insert the Pedal Arm Axle (64) into the Right
Upper Body Leg (60) and the Right Pedal Arm
(58) from the direction shown.
Next, slide an M8 x 22mm Washer (129) onto an
M8 x 13mm Screw (82), and tighten the Screw a
few turns into the Pedal Arm Axle (64).
Then, tighten the Pedal Arm Axle (64) and the
M8 x 13mm Screw (82) at the same time.
Repeat this step on the other side of the
elliptical.
82
129
60
64 Grease
58
4
110
63
101
92
92
Avoid pinching
the wires