31
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the elliptical is used.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in and that the power
switch is in the reset position.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the
displayed heart rate appears to be too high or too low,
see step 5 on page 23.
If the console does not display your heart rate
when you use the chest heart rate monitor, see
TROUBLESHOOTING on page 16.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFit account or iFit workouts, go to
support.iFit.com.
If the console does not boot up properly, or if the con-
sole freezes and does not respond, reset the console
to the factory default settings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting
the console requires two
people. First, press the
power switch and unplug
the power cord. Next, locate
the small reset opening
(A) near the USB port on the console. Using a bent
paper clip, press and hold the reset button inside the
opening, and have a second person plug in the power
cord and press the power switch. Continue holding the
reset button until the console turns on. When the reset
operation is complete, the console will turn off and then
turn back on. If it does not, press the power switch off
and then on again. Once the console turns on, check
for firmware updates (see step 6 on page 28). Note:
It may take a few minutes for the console to be ready
for use.
TABLET HOLDER TROUBLESHOOTING
If the tablet holder does
not stay in place, rotate
the tablet holder backward
and tighten the screw (B)
until the tablet holder stays
in place when it is rotated
to the desired position.
INCLINE SYSTEM TROUBLESHOOTING
If the ramp does not move to the correct incline level,
see step HOW TO CHANGE CONSOLE SETTINGS
on page 28 and calibrate the incline system.
B
MAINTENANCE AND TROUBLESHOOTING
A