25
4
BIIS OPERATION
D
Direct code entry
q
While in the standby condition, push [TX Code Enter] to enter
the TX code edit mode.
• Editable code digit blinks.
w
Push [TX Code Enter] to select the desired digit to be edited.
• Editable digit differs according to the setting.
e
Set the desired digit using [
]/[
]/[TX Code CH Up]/
[TX Code CH Down].
r
Push [TX Code Enter] to set the digit. The editable digit will move
to the right automatically.
t
Repeat
e
and
r
to input all allowable digits.
y
Push [P0] (Call) or [PTT]* to call.
* PTT call can be made only when PTT call capability is permitted.
NOTE:
When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and “
”
is
displayed during each call. However, an error beep sounds
and “
”
is displayed when no answer back is received
after the calls.
u
Push [PTT] to transmit; release to receive.
i
Push [P3] (Moni(Audi)) to send the “Clear down” signal.
For your information
When the “UpDate” setting for the call code is enabled, the set code
is overwritten into the call code memory.
Содержание UHF IC-F60
Страница 66: ...MEMO...
Страница 67: ...MEMO...
