iii
PRECAUTIONS
Common (MXP-5000/MXD-5000/EX-3187):
R
WARNING! NEVER
let metal, wire or other ob-
jects touch any internal part or terminals of these units.
This may result in an electric shock.
R
WARNING! NEVER
touch these units with wet
hands. This may result in an electric shock or damage
these units.
DO NOT
place these units near heating equipment
or in direct sunlight or where hot or cold air blows di-
rectly onto them.
DO NOT
use or place these units in areas with
temperature below –20˚C (–4˚F) or above +60˚C
(+140˚F).
DO NOT
place these units in areas that will block air
passage or put anything around these units. This will
obstruct heat dissipation.
DO NOT
use harsh solvent such as benzine or al-
cohol to clean these units, as they will damage these
units’ surfaces.
KEEP
these units out of the reach of children.
For MXP-5000 (Main unit):
R
WARNING! NEVER
apply AC voltage to the DC
input terminals of the Main unit. This may pose a fire
hazard, result in an electric shock or damage the Main
unit.
R
WARNING! NEVER
apply more than 32 V DC
to the DC input terminals of the Main unit or use re-
verse polarity. This may pose a fire hazard or damage
the Main unit.
R
WARNING! NEVER
cut the DC power cable
between the DC plug and fuse holder. If an incorrect
connection is made after cutting, the Main unit may be
damaged.
R
WARNING! NEVER
open the bottom cover of
the Main unit. There are no user adjustment points.
This may result in an electric shock and incorrect reas-
sembly may cause a fire hazard.
DO NOT
place the Main unit in excessively dusty en-
vironments.
KEEP
the Main unit away from heavy rain, and never
immerse it in the water.
The Main unit meets IPX4 requirements for splash
resistance when the supplied connection cables are
connected, and the connector cap is installed on the
other connector.
However, if it is dropped, splash resistance cannot be
guaranteed because of possible damage to the case
or the waterproof seals.
For MXD-5000 (Display unit):
DO NOT
place the Display unit in excessively dusty
environments.
BE CAREFUL!
The Display unit meets IPX7 require-
ments for waterproof protection when the rear cover,
and the access cover on the Front panel is closed.
However, if the Display unit has been dropped, water-
proof protection cannot be guaranteed because of pos-
sible damage to the Display unit’s case or the water-
proof seal.
For EX-3187 (Display extension unit):
KEEP
the Display extension unit away from heavy
rain, and never immerse it in the water.
The Display extension unit meets IPX4 requirements
for splash resistance when the connection cables are
connected.
However, if it is dropped, splash resistance cannot be
guaranteed because of possible damage to the case
or the waterproof seals.
