18
3
BIIS OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Direct code entry
D
While in the standby condition, push [P3] (TX Code Enter)
q
to enter the TX code edit mode.
• Code digit for editing blinks.
0 5 0 0
Push [P3] (TX Code Enter) to select the desired digit to
w
be edited.
• Digit for editing differs according to the setting.
Set the desired digit using [CH Up]/[CH Down]/[DIAL] or
e
10-keypad*.
*IC-F1821/D or IC-F2821/D only
Push [P3] (TX Code Enter) to set the digit, then the digit to
r
the right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [P3] (TX Code Enter).
Repeat
t
e
and
r
to input all allowable digits.
Push [P0] (Call) or [PTT]* to call.
y
* PTT call can be made only when PTT call capability is permit-
ted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
WAIT
”
is displayed during each call. However, an
error beep sounds and
“
FAILED
”
is displayed when no
answer back is received after the calls.
Push [PTT] to transmit; release to receive.
u
Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.
i
For your information
When the “UpDate” setting for the call code is enabled, the
set code is overwritten into the call code memory.