17
3
BIIS OPERATION
Transmitting a call
■
A total of 3 ways for code selection are available—selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.
Using call memory
D
While in the standby condition, push [P1] (Digital) to enter
q
the call code memory channel selection mode.
• “
” appears.
C A L L I N G
0 5 0 0
Appears
Push [Up] or [Down], or rotate [DIAL] to select the desired
w
call code.
Push [P0] (Call) or [PTT]* to call.
e
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
WAIT
”
is displayed during each call. However, an
error beep sounds and
“
FAILED
”
is displayed when no
answer back is received after the calls.
Push [PTT] to transmit; release to receive.
r
Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.
t
Calling back from the queue channel
D
While in the standby condition, push [P1] (Digital) for 1 sec.
q
to enter the queue memory channel selection mode.
Push [Up] or [Down] or rotate [DIAL] to select the desired
w
record.
< Q U E U E >
- Q U E U E ! -
Push [P0] (Call) or [PTT]* to call.
e
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
WAIT
”
is displayed during each call. However, an
error beep sounds and
“
FAILED
”
is displayed when no
answer back is received after the calls.
Push [PTT] to transmit; release to receive.
r
Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.
t