3
BASIC OPERATION
14
D
Setting subaudible tones for
repeater use
Some repeaters require subaudible tones to be accessed.
Subaudible tones are superimposed over your normal signal
and must be set in advance.
➀
Push [VFO] to select VFO mode.
➁
Push [BAND] to select VHF or UHF.
➂
Push [
(H/L)
SET] for 1 sec. to enter
set mode.
➃
Push [TONE] or [H/L] several times
until “rT” appears.
➄
Rotate [DIAL] to select the desired
subaudible tone.
➅
Push [
(VFO)
CLR] to exit set mode.
• Available subaudible tone frequencies
(unit: Hz)
T
T
67.0
79.7
94.8
110.9
131.8
156.7
171.3
186.2
203.5
229.1
69.3
82.5
97.4
114.8
136.5
159.8
173.8
189.9
206.5
233.6
71.9
85.4
100.0
118.8
141.3
162.2
177.3
192.8
210.7
241.8
74.4
88.5
103.5
123.0
146.2
165.5
179.9
196.6
218.1
250.3
77.0
91.5
107.2
127.3
151.4
167.9
183.5
199.5
225.7
254.1
USING
SET MODE
D
Setting an offset frequency
When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
➀
Push [VFO] to select VFO mode.
➁
Push [BAND] to select VHF or UHF.
➂
Push [
(H/L)
SET] for 1 sec. to enter
set mode.
➃
Push [TONE] or [H/L] several times
until “OW” appears.
➄
Rotate [DIAL] to select the desired
offset.
• Selectable steps are the same as the
pre-set tuning steps.
• MHz step may be helpful for large frequency changes—push
[
(VFO)
MHz] for 1 sec.
➅
Push [
(VFO)
MHz] to exit set mode.
■
Auto low power
When transmitting for 6 continuous min. at high power, the
IC-T7H automatically selects low power. This function cannot
be turned OFF and activates when the power supply is at ap-
prox. 11 V or more. To return to high power on transmit, select
receive, then switch back to transmit.
DUP
DUP
USING
SET MODE