12
4
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
■
Receiving
q
Set the audio level for the main band.
➥
Push the desired band’s [MAIN].
➥
Push [MONI•T/T-SCAN] to open the squelch.
➥
Rotate the main band’s [VOL] to adjust the audio level.
➥
Push [MONI•T/T-SCAN] to close the squelch.
w
Set the squelch level.
➥
Rotate the main band’s [SQL] fully counterclockwise in
advance, then rotate [SQL] clockwise until the noise
just disappears.
e
Set the operating frequency in the main band. (pgs. 11–13)
• When interference is received, push [ATT•PRIO] to turn the at-
tenuator function ON. (p. 17)
r
When receiving a signal on the set frequency, squelch
opens and the receiver emits audio.
• “BUSY” appears and the S-meter shows the relative signal
strength for the received signal.
■
Monitor function
This function is used to listen to weak signals without disturb-
ing the squelch setting or to open the squelch manually even
when mute functions such as the tone squelch are in use.
➥
Push [MONI•T/T-SCAN] for 1 sec. to open the squelch.
• Push [MAIN] to select the desired band (left or right) as the main
band in advance.
• “BUSY” blinks.
• Push [MONI•T/T-SCAN] again to cancel the function.
[MONI•T/T-SCAN]
Appears when receiving a signal.
