Icom IC-R1500, Инструкция по эксплуатации

Страница: 31 / 56

26
6
SCAN OPERATION
6
■
Scan start/stop
D
Preparation
Scan resume condition ((p. 29)); program the scan edges
((p. 27)); program two or more memory channels ((p. 17)); set
skip settings ((p. 28)), if desired.
D
Operation
q
Push [V/MHz•SCAN] to select VFO mode for full/pro-
grammed scan; or push [MR•SKIP] to select memory
mode for memory/bank scan.
• Select the desired bank in memory type selection mode for bank
scan.
w
Set the squelch level to the point where noise is just muted.
e
Push and hold [V/MHz•SCAN] for 1 sec. to start the scan.
• To change the scanning direction, rotate [DIAL].
• The memory channel readout blinks the scan type as below.
r
Push [TS•MODE] (or [SET•LOCK]) to switch full and pro-
grammed scan (P00 to P49), if VFO is selected in step
q
.
t
To stop the scan, push [V/MHz•SCAN].
About the scanning steps: The selected tuning step in
each frequency band (in VFO mode) is used during scan.
The bank-link setting can be changed in set mode. See
((p. 40)) for details.
• During full scan • During programmed scan • During memory scan • During bank scan
Indicates scan edge channels.
• P01 stands for 01A/01B
• P00 to P49 are available when
they are programmed, and
switches with [SET•LOCK].
Indicates bank channel.
Push [SET•LOCK] to se-
lect full (ALL) or program-
med scan (P00–P49) in
sequence.
While pushing and holding [V/MHz•SCAN], rotate [DIAL]
also to select full (ALL) or programmed scan (P00–P49).
NOTE: When SSB, CW, AM, FM or WFM mode frequencies
are programmed into memory channels disorderly, memory
scan takes a lot of time (very slow). Because changing
modes takes a time. In this case, assign the SSB, CW, AM,
FM or WFM mode frequencies into the separate bank
respectively. And using the bank scan is helpful.
IMPORTANT!: To perform memory or bank scan, two or
more memory/bank channels MUST be programmed, oth-
erwise the scan will not start.