Icom IC-F43DT, Инструкция по эксплуатации

Страница: 22 / 40

18
4
BIIS OPERATION
■
Transmitting a call
Total of a 3 ways for code selection are available—selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.
D D
Using call memory
q
While in the standby condition, push [P1] (Digital) to enter
the call code memory channel selection mode.
• “ ” appears.
w
Push [UP] or [DOWN] to select the desired call code.
e
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“ ”
is displayed during each call. However, an
error beep sounds and “ ” is displayed when no
answer back is received after the calls.
r
Push [PTT] to transmit; release to receive.
t
Push [MONITOR] (Moni(Audi)) to send the ‘Clear down’
signal.
D D
Calling back from the queue channel
q
While in the standby condition, push [P1] (Digital) for
1 sec. to enter the queue memory channel selection mode.
w
Push [UP] or [DOWN] to select the desired record.
e
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“ ” is displayed during each call. However, an
error beep sounds and
“ ”
is displayed when no
answer back is received after the calls.
r
Push [PTT] to transmit; release to receive.
t
Push [MONITOR] (Moni(Audi)) to send the ‘Clear down’
signal.
Call code text is displayed.
Appears
IC-F43GT_GS.qxd 04.4.9 1:10 PM Page 18 (1,1)