■
Setting the squelch level
The squelch circuit mutes the received audio signal, depending on
the signal strength and the squelch setting.
Rotate [VOL] to turn OFF the
q
transceiver power.
Set [ROTARY SELECTOR] to
w
any channel other than Channel
16.
While pushing and holding [PTT]
e
and [Lower], rotate [VOL] to turn
ON the power and enter the
squelch level adjustment mode.
Push [Upper] to increase the
r
squelch level (tight squelch), or
push [Lower] to decrease the
squelch level (loose squelch).
• The adjustable range is 0 (loose
squelch) to 9 (tight squelch).
• A beep sounds after pushing [Upper] or [Lower].
If the level is set on 0 or 9, an error beep sounds after pushing.
Therefore, you can determine the current level setting by the type
of beep that sounds.
Rotate [VOL] to turn OFF the power, then turn ON again to exit
t
the squelch level adjustment mode.
NOTE: This operation may not be available, depending on the
preprogramming. Ask your dealer for details.
16
3
OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
[VOL]
[Upper]
[ROTARY SELECTOR]
[PTT]
[Lower]
