© June 2011 Icom America
15
Programming Select Call with DTMF in 5-Tone
This procedure enables you to call a particular radio (selective call) using DTMF tones. The receive radio will
decode the tones.
Note: the receiving radio must have the UT-108 DTMF decoder board installed.
The following instructions assume that frequencies, tones, and squelch are set and the radios are in PMR mode
(found in the Menu bar under Model). Additionally, the Auto Reset Timer must be enabled (Memory CH) and a
value entered (Common -> Common). These instructions apply to all Icom radios with PMR capability.
TX Radio:
Memory Ch
Field
Setting / Description
CH Mute
Mute options depend on radio model:
Cont
(not muted) or
SGL
(muted until call is received)
Or
(not muted) or
AND
(muted until call is received)
Switch Action
»
Call
Set to
Audible
5Tone Signaling
»
Form
Set to
DTMF
5Tone Signaling
»
STN
Set to
1
. Points to 1
st
line in the TX Code CH window: target
Radio’s 5 Tone code
TX Code CH (under 5 Tone):
Field
Setting / Description
Line 1
Target radio ID
Line 2, 3…
5-tone for multiple target radios
Key and Display (under Common)
Field
Setting / Description
Key
»
P0-P3
Assign a key (right-click Conventional field to access
menu) for the following functions:
TX Code CH Select
— Enters the Code Select mode so
that you can select a target radio from the TX Code
Channel list.
TX Code CH Up
—Allows you to scroll through the target
radio list and select a radio. (As an alternative, you can
also use the Up/Down keys to scroll.)
Call
—Sends the 5-tone signal to the target radio.
Содержание IC-910H
Страница 1: ...PROGRAMMING GUIDE 5 t 5 t 5 one signaling...