Icom IC-7000, Руководство пользователя

Страница: 6 / 34

to test this modification with an autotuner, such as the LDG Z11 or Z100.
Your Icom 7000 Running Hot? ... Heres the FAN mod!
( This has been untested with an inline tuner )
1. Tuner Lead #3 is +12v DC, tap into Tuner Lead #3 with a wire ( theres enough room
to simply slip a solid copper wire into the crimp for lead #3 )
2. Add a 100ohm Resistor at the other end of the solid copper wire ( a 100ohm pot will
work if you wish to be able to vary the speed of the fan )
3. Strip the insulation of the red wire to the fan back just enough to make a solder
connection to the 100ohm resistor / 100ohm pot. We used a lighter to burn away a
bit of the insulation in the middle of the wire b/t where it connects to the board and
where it connects to the fan itself.
Wrap it all up with some electrical tape to prevent grounding. and Whala! Your Done!!
Tuner Port on back of the IC-7000
^
1
2
3 +12v DC -> wire -> 100ohm resistor -> fan red wire
4
-
A 100ohm Pot could be used instead of a resistor, values below the 100ohms will increase
fan speed.
0 resistance - sounds like an airplane.