3
1
INSTALLATION AND CONNECTIONS
New2001
New2001
BASIC MANUAL
■
Installing the controller (Continued)
D
Attaching to a flat surface
You can install the controller on a flat surface with the optional
MBA-8
controller
bracket
. When attaching the MBA-8 to a
wall, use self-tapping screws*
1
(3 mm, 0.12 in (d)).
1. Attach the MBA-8 to a wall.
MBA-8
Self-tapping screw*
1
(3 mm, 0.12 in (d))
■
Connecting a microphone
Plug in the microphone into the microphone jack on the
main unit.
Controller
Main unit
Microphone
⊕
−
■
Connecting to a DC power
supply
Confirm that the transceiver is
OFF, then connect to a 13.8 V
DC power source with at least
15 A capacity.
R
WARNING! NEVER
remove the fuse holders from
the DC power cable.
When you attach a screw to this
hole, use a self-tapping screw*
1
(4 mm, 0.2 in (d)).
2. Attach the magnets to the controller’s rear panel with
the supplied shorter screws (M2.6 × 6 mm).
DC power
supply 13.8 V
Red line:
+
Black line:
_
To an
AC
outlet
Fuses 15 A
CAUTION: DO NOT
reverse
the polarity when connecting
the DC power cable.
*
1
User supplied
3. Attach the controller to the MBA-8 that is attached to a wall.
Magnet*
2
Shorter
M2.6 × 6
screws*
2
Controller
NEVER
use any screws other than the supplied shorter
screws (M2.6 × 6 mm) to attach the magnets. Otherwise
the transceiver’s internal board may be damaged.
*
2
Supplied with the MBA-8.
