2
SCAN OPERATION
2-4
1. Push [V/M] several times until you enter the VFO
mode.
2. Hold down [SCAN] for 1 second.
•Opens the Scan Type Select window.
L
If you hold down [SCAN] for 3 seconds, the last
selected scan starts.
3. Rotate [DIAL] to select a scan type, then push
[
ï
].
•The scan starts.
L
The decimal point and the selected scan type icon
blink.
L
When receiving a signal, the S-meter displays the
received signal strength.
4. Push [SCAN].
•Cancels the scan.
VFO mode scan
D
Scan type
The VFO mode scan has 6 scan types.
•ALL:
Full scan
•BAND:
Band scan
•P-LINK0 ~ 9: Program link scan
•P00 ~ 24:
Program scan
•DUP:
Duplex scan
(Displayed only when duplex is set.)
•TONE:
Tone scan
(For the Tone Squelch scanning)
L
The frequencies that are set as a Skip channel (PSKIP)
are skipped during a scan. (p. 2-8)
L
When “Program Skip” is set to “OFF,” the Skip channel
frequencies are not skipped. (p. 9-18)
(Scan >
Program Skip
)
TIP:
• During a scan, rotating [DIAL] changes the
scanning direction.
• During a scan, you can change the operating
band, scan edge, and so on, in the Quick Menu
window.
• The scan continuously runs, even if you push
[MENU] or [QUICK] during a scan.
• You can set the tuning step and the operating
mode used for a Program scan or Program Link
• The transceiver can receive on the AIR, 144 MHz,
230 MHz, 300 MHz, and 430 MHz bands.*
* Selectable band differs, depending on the transceiver’s
version.
L
You can transmit on only the amateur band
frequencies.
[DIAL]
[ ]*
[QUICK]
[V/M]
[SCAN]
*The key operation may differ,
depending on the operating status.
Previous view