Icom D-STAR ID-31A; D-STAR ID-31E, Инструкция по эксплуатации

Страница: 61 / 80

52
8
TROUBLESHOOTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
PROBLEM POSSIBLE CAUSE SOLUTION REF.
After your call, the repeater
does not transmit a reply. • The repeater setting is wrong.
• The transceiver is out of the repeater range, or
your transmission does not reach the repeater.
• Set the correct repeater.
• Correct the repeater frequency, frequency offset, or
duplex setting.
• Try to access another repeater.
Advanced
Instruction
Section 3
After your call, the repeater
replies ‘UR?’ and its call
sign.
• The call was successfully sent, but no station’s
signal was immediately received.
• Wait for a while, and try it again.
After your call, the repeater
replies ‘RX’ or ‘RPT?’ and
the call sign of its gateway
repeater.
• MY call sign has not been set.
• Your call sign has not been registered to the
D-STAR Server. Or it’s wrong.
• Your calling station call sign has not been regis -
tered to the D-STAR Server. Or it’s wrong.
• Set the MY call sign.
• Register your call sign to the D-STAR Server. Or con
-
firm the registration of your call sign.
• Ask the server’s administrator about your calling sta -
tion’s call sign.
After your call, the repeater
replies ‘RPT?’ and call sign
of the called repeater.
• The D-STAR cannot connect to the called re -
peater, or it’s busy.
• Wait for a while, and try it again.
After your call, the repeater
replies ‘RPT?’ and its call
sign.
• The call sign of the called repeater is wrong. • Correctly set the called repeater call sign.
Even holding down , the
DR mode will not appear.
• The repeater list has been cleared. • Reprogram the repeater list using the CS-31 clon -
ing software.
• Reprogram the repeater list with the transceiver.
Even holding down , the
received call sign will not
set to the operating call
sign
• The call sign has not been correctly received. • Try it again, after the transceiver has again received
its call sign.
The repeater does not ac-
cept your gateway call. • Your call sign has not been registered to the D-
STAR system
• Ask your desired repeater’s administrator about call
sign registration.
• While operating D-STAR