SETTING DATA INITIALIZATION
10
63
There may be times when you wish to readjust the
settings from the beginning or delete existing setting
data, such as when changing the network configura-
tion. The setting data can be returned to the original
factory settings using one of the three methods (
Å
,
ı
, or
Ç
) listed below.
This chapter explains
Å
and
ı
only.
Å
Use the <INIT> button (
☞
p. 63)
ı
Use the setting screen (
☞
p. 65).
Ç
Use the Utility (
☞
p. 67).
* To use the Utility, install it from the included Utility
Software disks. See “12 Utility Software” (
☞
p. 67) for
instructions regarding how to install the Utility.
Å
Using the <INIT>
button
Use the following procedure to initialize the setting
data in situations where you cannot access the AP-3
setting screen, such as when the current IP address
setting of the AP-3 is unknown.
1. Disconnect all network devices except the AP-3 unit
and the setting terminal (wired or wireless) that will be
used to conduct the initialization.
2. Hold down the <INIT> button. Then supply power to
the AP-3 unit or lightly press and release the <RESET>
button.
• The [LAN] lamp and the
lamp will flash
in unison.
3. Release the <INIT> button when the <POWER> indi-
cator lamp starts flashing.
• The <POWER> lamp will continue to flash slowly
while operating in [Setting Initialization Mode].
4. Start up the setting terminal.
5. Open the web browser of the setting terminal and a
designate the original factory-set IP address (
☞
p. 42)
of the AP-3 in the URL text box.
• The [Initialize mode] screen is displayed.
