ELECTRONIC CIRCULATOR FOR HEATING SYSTEMS - Art. P329
ICMA S.p.a. - Heating Technologies - www.icmaspa.it
FI.P329.EN.C - 1 /2022
Icma SpA - Via Garavaglia, 4 - 20012 Cuggiono (MI) ITALY Tel: +39 02 97249134 - +39 02 97249135 - www.icmaspa.it - [email protected]
4
2. IMPORTANT SAFETY AND INSTALLATION INSTRUCTIONS
Prior to installation, read these installation and operating instructions. The installation and operation should also be in
accordance with national regulations and accepted codes of good practice.
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of experience
and knowledge, only if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
To guard against injury, basic safety precautions should be observed, including
the following:
1. Read and follow all safety instructions
and all the important notices on the
appliance before installing, using and maintaining the circulator. failure to do so
may cause personal injury or damage to the circulator or installation.
2. Always disconnect electrical supply
before putting on or taking off parts
and whilst the equipment is being installed, maintained or handled. Never
work with bare feet and/or with wet hands.
3. To avoid possible electric shock, special care should be taken since
water is used with electrical equipment.
Carefully examine the circulator
before and after installation. Do not operate the circulator if it has a damaged
supply cord or enclosure, or if it is malfunctioning or it is dropped or damaged
in any manner. Inspect the circulator periodically. The circulator should not be
electrically supplied if there is water on parts not intended to be wet
.
4. Risk of scalding.
To avoid injury before any servicing operation wait until the water has cooled
inside the circulator.
Do not touch the fluid or the circulator when temperature is higher than 60°C.
