
Display Error Messages
Lifted wheel
Move the robot to an even place.
Blade and brush motor
overload
Check if a foreign material such as hair or lint is
caught in the main brush, and remove it.
Suction motor overload
Clean the filter and empty the dust bin.
Internal system error
Turn off the power switch of the robot, then turn
it on again.
Turn off the power switch of the robot, then turn
it on again.
Magnetic sensor (adjacent
to the front wheel) error
Check if the front wheel and magnetic sensor are
clean, and properly installed.
Gyro sensor error
Cause
Display
Solution
Dust bin error
Dust bin is not properly installed. Refer to
Maintenance part in the user manual.
Wheel motor overload
Check if a foreign material such as hair or lint is
caught in the wheel, and remove it.
Cannot detect floor
Move the robot to an even place in case the wheels
are stuck on an obstacle.
18
A
ctio
ns
fo
r D
isp
lay
E
rro
r M
es
sa
ge
s
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
CAUTION : Changes or modifications not expressly approved by the manufacturer responsible for compliance could
void the user’s authority to operate the equipment.