icetro ID-150AN, Руководство пользователя

Страница: 21 / 32

21
6. Required Actions to prevent frost
If the ambient temperature falls below 32 ℉, water will freeze inside the machine and machine
operation will be impossible.
If you do not use for a long period of time in winter, be sure to completely remove the ice making
water inside the body by following the instructions below. If you do not remove the ice making
water or if it is insufficient, it will cause serious damage to the product.
This shall not be guaranteed by the manufacturer and may result in a lot of repair costs.
Please observe the following points.
Caution
1. Turn on the power switch and press the
DOWN + SET button at the same time for
3 seconds with any signal on the FND window.
Forced drainage will be done for 30 seconds.
2. Turn off the power switch and disconnect the power
plug from the outlet.
3. Remove the upper panel → the front panel.
4. Remove the evaporator cylinder drain hose clamp
and remove the hose, and wait until the ice in the
evaporator cylinder completely melts down.
(It is possible to remove internal water quickly by
using compressed air gun etc.)
5. Reassemble the evaporator cylinder drain hose
and tighten the clamp.
6. Assemble in the order of left panel → upper panel
→ front panel
Water Removal in Water Tank and Evaporator
Clamp
Power
switch
UP button
DOWN
button
SET
button
FND display window
ICE MAKING-
OFF-WASH switch