icetro A25B15O, Руководство пользователя, Страница: 22 / 28

22
■ Ice Machine cleaning and sanitizing ■
The type and concentration of sanitizing agent(Ice Maker Cleaner, Sanitizer, mild or neutral detergent,
and so forth)recommended
Comply with 40 CFR 180.9403 or
Be registered with the USA Office of pesticides program Antimicrobials Division
As a food contact sanitizer and
- If produced by a device, as defined per 40 CFR 152.5003, be demonstrable to be efficacious per USEPA
performance. The device shall maintain a USEPA Site manufacturing device establishment number and
- If produced by a device, as defined per 40 CFR 152.5003, have in place and readily discernable
to the operator a monitor or indicating device that the device is producing adequate amounts of sanitizing
agent during the sanitization operation.
• General
The end user is responsible for maintaining this ice maker according to the instructions in this manual.
The maintenance procedure is not covered by insurance.
Basic sanitation and maintenance of the ice maker will increase the reliability and performance of your ice maker
and also reduce the consumption of water and electricity.
Managing the ice maker according to our instructions will minimize unwanted repairs that might occur while in use.
The table below shows the maintenance activities and their frequencies that the end consumer and the service
technicians shall perform.
These figures are minimum requirements. If the water is supplied to the ice maker in poor quality,
the evaporator must be cleaned more frequently. If the condenser air filter is completely clogged,
it should be cleaned more frequently on a weekly basis.
※ Warning: If you do not fully understand essential safety regulations and procedures, please contact the
distributor to carry out the necessary repair.
[Cleaning and Sanitizing Inside]
• General
Clean and sanitize the ice maker every six months for efficient operation.
If the ice maker needs to be cleaned and sanitized more frequently, consult a certified service company
for water quality testing and take appropriate action.
If the internal condition of the ice maker is poor, it is necessary to disassemble major parts of the ice maker
for cleaning and disinfection.
※ Caution: Use only the certified ice-maker detergent and disinfectant. (The detergent can be purchased
through us or our distributor.) Please read the label printed on the container before use before
cleaning or Sanitization. Do not mix the detergent and the disinfectant.
※ Warning: Wear rubber gloves and goggles (or face cover) when using the detergent or the disinfectant.
• How to Wash
Ice maker detergent is used to remove mineral deposits
such as lime marks. It cannot be used to remove fur or adhesive mucus.
Mix 4 liters of water and 150 ml of detergent in a plastic
or stainless steel container.
Step 1
: After the ice falls off the evaporator, turn off the switch at the end of the ice separating cycle.
Or turn the switch to OFF so that the machine will automatically complete make and separate ice and stop.
※ Caution: Do not remove ice from the evaporator by using excessive force. It can damage the evaporator.
Step 2
: Remove all ice inside of the tank. (If you wish to use the ice again, keep it in a suitable separate container.)
※ Warning: Before proceeding, shut down the power to the icemaker in the electric switch box.
(Leave the earth leakage breaker OFF or leave the ice maker switch OFF)
Step 3 : Our ice makers are generally divided into two types. Take cautions when disassembling parts
as they are disassembled differently and the different parts are disassembled depending on the type.
Detergent (Nickel Safe Cleaner) Water
Water
150 ml (5.1 oz) 4 Liter
200 ml (6.7 oz) 5 Liter
Disinfectant (5.25% Sodium Hypochlorite)