iceqube EX series, Руководство по эксплуатации и установке

Страница: 6 / 25

6
Rev. 1
Preparing the Enclosure
Please read entire section before beginning installation. The Ice Qube TMS has been designed to be light in
weight for easy installation. Side mount units have been designed with a simple two stud alignment feature
to make initial fastening to the enclosure quick and easy. A few modifications must be made to your
enclosure to provide proper air flow, maintain enclosure integrity, and assure secure installation. Required
modifications will vary with Ice Qube TMS model.
1. Ensure the mounting surface and enclosure will support the weight of the Ice Qube TMS and will
not become unstable causing bodily harm or equipment damage. For units mounted on enclosure
doors, confirm hinges will support the weight of the Ice Qube TMS. Refer to individual
specification drawings for model weights.
2. Using the specification drawing, determine the ideal location to install the Ice Qube TMS on your
enclosure.
3. Upon deciding the installation location of the Ice Qube TMS on your enclosure, use the cutout
drawing to determine the necessary modifications to your enclosure surface needed to
accommodate mounting of the Ice Qube TMS. An Electronic copy is available at
http://www.iceqube.com/downloads/specification-drawings/
4. Ensure the Ice Qube TMS will be mounted level.
5. Ensure the inlet and outlet of the cold air stream will not be restricted by equipment or shelving
within your enclosure.
6. Check that the air flow of the warm air stream will not be affected or restricted.
7. Confirm the gasket is properly installed to the Ice Qube TMS. This gasket is required to create a
seal against your enclosure and will maintain enclosure integrity.
(See Figure 11 pg:21 and Figure 12
pg:22)