Never place the appliance next to naked flames or other heat sources.
Do not open the lid more often than required. Do not leave the lid open more
often than is necessary. This will influence the duration of the cooling or keeping
warm.
The duration of the cooling or keeping warm is also dependent on the ambient
temperature.
The appliance is not suitable for permanent operation.
The appliance can be connected to two different energy sources.
-
Alternating current 220V~
-
Direct current 12V
The respective indicator lamp will indicate the mode:
-
Green for cooling
-
Red for keeping warm
Do not switch directly from one operating mode into the other. If you would like
to change the operating mode, turn the appliance Off. Wait about 30 minutes
before you switch it to the other operating mode.
Cooling
You may keep cold foods cold for several hours.
Turn the switch to the “COOL” position
For best results, only store already cooled food/ beverages in the cooler. Select
a place of use that is protected from direct sunlight.
Keeping warm
You may keep hot food / beverages warm for several hours, maximum 50°C to
60°C
Set the switch to the “HOT” position.
The peltier element will switch off and on at intervals to maintain the
temperature. The red control light will be lit up when the peltrier element is in
operation and when the fan is running.
The appliance is not designed for reheating. Cold food will only warm up slightly
after about 2 hours.
Connection to the alternating current
1.
Remove the power cord for the direct current, if necessary.
2.
Check to make sure that the mains voltage that you want to use is 220 V~.
3.
Plug the power cord for alternating current into the ~AC socket on the appliance
(see Fig.)
4.
Connect the device to a properly installed earthed socket.
5.
Set the switch to COOL for cooling and to HOT for keeping warm.
Connection to the direct current
1.
Remove the power cord for the alternating current, if necessary.
2.
Turn on the engine of the motor vehicle.
