iCentral System One M200, Руководство по установке, Страница: 34 / 44

30
30
AUX1 OPTIONS MENU
 – programmable from 1 to 99 seconds or 1 to 99 minutes
– output turns on when AUX button pressed followed by 1
– output turns off after programmed duration

– Output turns on and off each time AUX followed by 1 is pressed

– Output turns on 2 seconds after the chime is activated
for the programmed duration.
 – This output can be used to activate a DVR or various other video
capture devices when the chime is activated
AUX2 OPTIONS MENU
As per Aux 1 Options but applicable to Auxiliary Output 2
OTHER OPTIONS MENU
 – The Gate Status Input which activates the Gate Status LED on the front of the
master can be programmed to normally open (N/O) or normally closed (N/C) depending on switch used
and customer preference as to whether LED is on when gate is open or gate is closed.
 – Once intercom has been set up after installation, the settings can be saved by
pressing 1. If someone inadvertently changes critical settings, the original settings that were saved can
be restored by pressing 2
 – The default factory settings can be reloaded if required by pressing 1
SYSTEM TEST MENU
This menu is primarily for factory testing however it can be used to selfcheck various aspects of the
system.
 – Pressing various keys will show verification on the screen. Navigation and Clear
keys will not show verification but instead perform their respective function.

– Functioning LEDs will flash

– This test will show if there is a fault with regard to any of the master’s voltage
level control input/output terminals including open circuit output or excessive
external loading  i.e. shorts etc
 – This test applies to VLC, VLC1, VLC2, VLC3, TC and AUX terminals.
 – This test requires that Auxiliary Output 1 be temporarily linked to the
Gate Status input
 – This test requires that Auxiliary Output 2 be temporarily linked to the
Gate Status input