Icematic DX 40, Руководство по обслуживанию

Страница: 10 / 24

O. To check for the correct operation of the
dispensing system place one hand or an ice
bucket close to the photoelectric sensor located
on the front side of the dispensing compartment.
The auger motor starts immediately turning the
dispensing auger till the photoelectric sensor is
activated by the hand.
NOTE. The P.C. Board is adjusted to provide
power to the auger motor for a maximum of
15 seconds just to avoid to overfill the ice
bucket when left in the dispensing
compartment.
The yellow LED, located beside the green one, is
lighted ON while the auger motor is energized.
NOTE.
The CUT-IN RANGE OF THE ICE
LEVEL CONTROL SENSOR can be
adjusted by means of the DIP SWITCH keys
8 and 9 as shown on table D of PRINCIPLE
OF OPERATION; its cut out setting remains
however at +2
°
C (35
°
F).
M. Remove if fitted the refrigerant service
gauges and re-fit the unit service panels
previously removed.
N. Instruct the owner/user on the general
operation of the ice machine and about the
cleaning and care it requires.
Page 9