www.ICELED.co.uk
MATRIX GUIDE v1
4
just by toggling the switch controlling power to the device. A single flash from the
LED's provides acknowledgment that the freeze command has been accepted.
Un-freezing
The light source will remain frozen on the chosen colour until the next
time it is switched off. Once again, if the supply is interrupted for less than a second,
the programme will resume from where it left off (acknowledged by two flashes) If
switched off for any longer, the programme will resume from the start the next time
it is powered up.
Specifications
Nominal supply voltage:
12 Volts DC (
1
)
Maximum current drain:
0.25 Amps
Typical current drain:
0.1 Amps
Max. power consumption:
3 Watts
Beam angle:
120 degrees
Data accepted:
Global ICELED or UFO tube segment 0, pixel 0 (
2
)
Environment:
IP68
Dimensions:
W 50mm, L 50mm, H 15mm
(
1
) On-board current regulation guarantees that the light source operates
consistently at peak intensity over a wide supply range of between 8 and 28 Volts.
Brief surges above this range can also be tolerated. Reverse polarity protection is
built in.
Use in 24V electrical systems may be restricted to standalone mode as
ICELED controllers are currently only available for operation at 12V.
(
2
) UFO controllers produce Global ICELED data that complements the tube data.
Additional resources
To see the full ICELED product range visit http://www.iceled.co.uk - the official
ICELED website.
For interactive help and advice visit http://iceled.co.uk/area51/ - the official ICELED
user forums.
EMC Directive (2004/108/EEC)
ICELED MATRIX Conforms to:
