6
Section 3. Operating the Appliance
3.1. Switching on the Appliance
Allow the appliance to stand for a minimum of 4 hours after installation.
Plug in the appliance and switch on at the mains supply.
Set the thermostat control to the required setting as detailed in the
Temperature Control section (3.2.).
Leave the appliance for approximately 4 hours for the correct temperature
to be reached.
3.2. Temperature Control
The temperature selector knob is located on the right hand side of the inner
cabinet (see Description of the Appliance on page 2). Please note that a larder
fridge does not have an ice-box and will operate at a slightly higher temperature
than a fridge with an ice-box.
Setting “0”: Unit Off
Setting “1”: Unit On – Warmest Temperature
Setting “3” to ”4”: Normal Operation (adequate for most situations)
Setting “7”: Coldest Temperature
Important!
During high ambient temperatures e.g. on hot summer days, it may be necessary
to set the thermostat to the coldest setting (position “7”). This may cause the
compressor to run continuously in order to maintain a low temperature in the
cabinet.
Your appliance is fitted with a unique Frost Protection Thermostat. The
ON/OFF switch located on the interior Thermostat Dial/Light Unit (see pic.1
below) should always remain in the “OFF” position except in the following
conditions:
Where the appliance is located in a garage or out-building and the
ambient temperature has fallen below zero for an extended period, you may find
that the temperature inside the larder unit is not as cold as normal, if this happens
simply press the switch to the “ON” setting. This will turn the compressor on and
the interior temperature will recover within a few hours. Turn the switch back to
“OFF” as soon as the temperature has recovered.
WARNING! DO NOT LEAVE
THE SWITCH IN THE “ON” POSITION FOR MORE THAN 6 HOURS!
Pic.1.
