10
Remove the plastic Upper Hinge Cover (1)
Remove the retaining screws and the Top Hinge (2)
Lift the door off the Lower Hinge (4).
Remove the retaining screws and the Lower Hinge (4)
Remove the Hinge Pin and Foot from the Lower Hinge (4), turn the hinge
over and refit the Hinge Pin and Foot.
Remove the Foot (5) from the left hand side and refit on the right hand side.
Now fit the Lower Hinge (4) to the pre-drilled holes on the opposite side of
the cabinet
Remove the Plastic Caps (6) from the top left hand side and refit on the
right hand side.
Locate the Door (3) onto the Lower Hinge (4) and refit the Top Hinge.
Ensure that the door closes and seals correctly – tighten all the screws.
Refit the Top Hinge Cover (1)
4.6. What to do if something goes wrong
There is no power to the appliance:
Check there is not a power cut
Check there is power to the electric socket/appliance
Check the fuse in the plug (Must be 13 amp)
The compressor runs continuously:
Is the door closed correctly?
Have large quantities of food recently been added to the appliance? – if
yes, allow the interior temperature to recover
Has the appliance door been opened frequently? – if yes, allow the interior
temperature to recover
Is the “ON/OFF” Frost Protection switch located on the interior light unit in
the “ON” position – if yes, turn it to
“OFF”
The appliance is making a noise:
Refer to Normal Operating Sounds, section 3.4.
Ensure that the appliance has been installed correctly (see section 1).
If after the above checks there is still a fault please contact your retailer
.
SERVICE HELP-LINE
Should your appliance develop a fault, please call the
Repairtech Service Helpline on:
01527-888133
